Used Clean In Place - CIP Systems

Stock# 51188008

New/ Unused Three (3) Tank CIP (Clean In-Place) System consisting of the following: 2 x 2,000 316 stainless steel acid & caustic chemical tanks, Insulated, Top manway, Level transmitter, RTD Temperature probe, 1 x 2,000 L 304 stainless steel Water re-use tank, Single skin, Top manway, 1 x Spray ball, Level transmitter, RTD Temperature probe, Automated valving, 9 x Automated butterfly valves, 1 x Automated control valve, 7 x Solenoid valves, Manual valving, 17 x Manual valves, 1 x Stainless steel sanitary design centrifugal pump for CIP supply including Stainless steel shroud, VSD (variable speed drive), Local motor isolators, 2 x Stainless steel centrifugal pumps for CIP heating including Stainless steel shrouds, Local motor isolators, 2 x Concentrated diaphragm chemical pumps, 1 x Grundfos sanitizer dosing pump, 1 x 500 micron (mesh size) stainless steel filter, 1 x 2 section stainless steel plate heat exchangers for heating CIP solution, 1 x Stainless steel plate heat exchanger for heating water, 3 x Concentrated chemical suction lances, Stainless steel process control cabinet including Remote I/O, 1 x VSD, 3 x Conductivity probes, 4 x RTD temperature probes, 3 x Level transmitters, 1 x Mag flowmeter, 3 x Level switches, Electrical switchgear, Ethernet switch, etc.

Stock# 53232001

Used IDD Manual CIP/SIP (2) Tank System, Consisting of: (1) 250 Gallon stainless tank caustic tank, (1) 250 gallon stainless steel acid tank; Goulds 5HP vertical pump; Rosedale stainless steel filter; (3) poly tanks, panel. The unit will supply caustic and acid at up to 150 degrees F, pre-rinse with recovered water and final fresh rinse water with Oxine sanitizer to rinse the tanks and associated process lines. Mounted on a stainless steel frame.

Stock# 53485003

Used 3-Tank Clean In Place (CIP) System.

Stock# 11252233

Unused A&B Process Systems 2-Tank CIP Skid with (2) 250-Gallon 316L Stainless Steel Tanks with insulated vessels rated for 15 PSI / Full Vacuum at 350 degrees Fahrenheit to minus 20 degrees Fahrenheit Minimum Design Metal Temperature (MDMT). Skid mounted system with 57" wide x 116" long. Includes 20 HP centrifugal pump, driven by 230/460 Volt, 3510 RPM, 3-phase, 60 Hz motor. Offered with Ashcroft pressure gauges and Rosemount temperature transmitters. Vessels are mounted on Mettler Toledo 0959 load cells. Non-product contact parts are 304 stainless steel. Product contact parts are 316L stainless steel. System rated for 480 Volt, 3-phase, 60-cycle. Previously used in pharmaceutical environment. NO CONTROLS WITH THIS SYSTEM.